These are recommended for MOST 4.7L Performance builds. To be used with our ROSS Pistons.

These Scat I-beam connecting rods will support over 700HP @ 7500rpms all day long. They incorporate all of the best features possible for an I-beam rod, including some strength adders found in H-beam designs. Scat Pro Comp I-beam connecting rods are profiled with clearance for long stroke applications. Good for applications up to 700+RWHP.

These I-beam Rods weigh less than their equivalent H-beam rods however are strong enough to handle over 700HP. There is no reason to run a heavier H-Beam Rod unless you feel you will make north of 800HP+HP.

These connecting rods with ARP 8740 7/16 bolts are rated to 700 Horsepower on Small blocks, and 800 horsepower on big blocks. When used on a short stroke engine such as the 4.7L 3.10 stroke these rods are virtually indestructible.

These connecting rods feature a one-rib cap design for added strength and bearing support, polished beams to eliminate stress risers, and special hollow dowels with huge 7/16 in. ARP cap screw bolts to greatly increase strength and horsepower capabilities.

Air Ram Performance takes these brand new Scat rods and modifies them to fit your 4.7L engine.

Brand: SCAT Engine Components
AIR RAM PERFORMANCE Part Number: 287-2-ICR6125-7/16-8740
Part Type: Connecting Rods
Product Line: Scat Pro Comp I-Beam Connecting Rods
Connecting Rod Length Center to Center (in): 6.125 in.
Connecting Rod Beam Style: I-beam
Connecting Rod Material: Forged 4340 steel
Connecting Rod Finish: Shot-peened
Wrist Pin Style: Floating
Clearanced for Stroker: Yes
Cap Retention Style: Cap screw
Connecting Rod Bolt Brand: ARP
Connecting Rod Bolt Diameter: 7/16 in.
Connecting Rod Bolt Material: 8740 chromoly steel
Fastener Yield Strength (psi): 200,000 psi
Connecting Rod Bolt Head Style: 12-point
Approximate Connecting Rod Weight (g): 610
Rod Journal Diameter (in): 2.100 in.
Big End Bore Diameter (in): Machined to fit standard 4.7L main bearings.
Pin End Bore Diameter: 0.927 in.
Big End Width (in): Machined down to fit standard 4.7L crank mains.
Weight Matched Set: Yes
Magnafluxed: No
Quantity: Sold as a set of 8.